Views: 0 Author: Site Editor Publish Time: 2015-05-22 Origin: Site
How to lubricate the planetary reducer? The planetary reducer needs to be lubricated when it runs like other reducers, so that not only can accelerate the operation of the planetary reducer, but also protect the normal operation of the reducer. How to lubricate the planetary reducer? Let's take a look at the detailed explanation of the Shanghai Jinchuan reducer below. When selecting the grease according to the bearing load of the traveling planetary reducer, the grease with small penetration for heavy loads should be selected. When working under high pressure, in addition to low penetration, it also has higher oil film strength and extreme pressure performance. When selecting grease based on environmental conditions, calcium-based grease is not easily soluble in water and is suitable for dry and low-water environments. When selecting grease according to working temperature, the main indicators should be dropping point, oxidation stability and low-temperature performance. The dropping point can generally be used to evaluate high-temperature performance. The actual working temperature of the bearing should be 10-20℃ lower than the dropping point. The use temperature of synthetic grease should be 20-30℃ lower than the dropping point. The lubrication method of the planetary reducer is also an aspect that causes poor lubrication. The splash type lubrication method is mainly used for high-speed occasions. It is obviously inappropriate for this medium load and low-speed situation. Long-life, low-maintenance enclosed full-life gearboxes, boiler row feed gearboxes, gear chain stepless transmission, planetary reducer lubrication, can also be used for the lubrication of centralized grease supply equipment. The unreasonable lubrication method of the planetary reducer and the defects in the structural design have led to the unreliable application of this planetary reducer. The problems reflected, first are the reduced service life, and secondly, the loud noise and vibration, resulting in frequent maintenance. Moreover, the eccentric bearing and needle gear sleeve must be replaced every time the maintenance is performed, which increases the maintenance cost. The work of the bearing is not very stable. Due to the effect of gravity and the vibration generated by the mechanical movement, the bearing will inevitably cause a slight displacement in the axial position of the bearing. This relative movement is very harmful, and constant impact may cause the elastic ring The deformation and breaking of the bearing may cause the bearing to fall off the shaft. Even if the bearing does not fall off, it will generate a lot of noise due to vibration. Jiangsu Taixinglong reducer specializes in the production of various reducers. Website: http://www.txlreducer.com/ Welcome to negotiate and purchase.